Rear Cabin Lights (Part 3)

Time 3.25 hrs

More work on the rear cabin lights today and yesterday. Now I need to wait for a few parts to finish it up. It’s getting there. I’m kind of wishing I just bought the Aveo lights, it would have saved a lot of time.

I had to change the way I did the dimming and switching of teh front lights because of the way the lights are wired. The Airkit lights for some reason have a single power lead and two grounds , one for the white light and one for the red (rather then a single ground and seperate poor for each colored light). I didn’t like how the potentiometer was dimming the lights so I wanted to use a PWM dimmer to get better dimming. The problem is you can’t dim on the ground side so I had to do away withe the dual concentric knob idea and go with a double throw switch (to select the red or white light) and pot to control the PWM dimmer. It’s a bit of a tight fit to get the switch and pot on the mounting plate, but the tiny pot that comes with the dimmer helps. The pot also has a switch built in so that removes the need to put that in the dual throw switch.

I made a new anodized plate (I didn’t like the gray one) and did the cut outs for the dual throw switch and pot. I found a nice knob made by Kilo International on Allied Electronic’s site. They make a few styles so I purchased a few different ones to see what would work best.

Ran the wire to the rear cabin lights and pinned the ends for the connectors. The rear lights just use a 2 pin connector (+14V and Ground). This will connect to the touch dimmer and I’ll just wire that directly to the light. Oh and I also riveted in the nut plates as well.

It’s getting there. I never imagined it would take this long to get everything installed and wired up. There’s been a lot of trial and error. mainly because the space is so minimal in the canopy roof. The small circuit board hanging is the PWM dimmer (really a motor control) that I got off Amazon. It takes 14V in and then just a connection out to provide dimming for the lights. The ground side will go into the double throw switch. The PWM dimmer has a connector for the on/off switch and another for pot.

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

This site uses Akismet to reduce spam. Learn how your comment data is processed.