Horizontal stabilizer skin prep

Time: 3.5 hrs

Did a test fit of the horizontal stabilizer skins, deburred, and primed them as well. Wow these were possibly the worse ones yet. I had done a previous test fit and so I had marked each skin for left and right, but maybe I messed up because I couldn’t get the skins to fit. I flipped them around and was then able to get the skins to cleco right. Still after all that there was quite a bit of match drilling and a few spots where the holes were off a bit. I did check that the lines I drew on the end ribs where at the same angle so the horizontal stabilizer should be straight.

 

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s